fbpx
//MK K4015 Superior Range Recessed PIR Sensor

MK K4015 Superior Range Recessed PIR Sensor

£22.99 £13.99

9 in stock

Sensor with Presence Or Absence Detection with Photocell Program Feature

9 in stock

SKU: K4015 PIR Category:

Description

MK Sensors are designed to help you save money on your energy bills across a variation of commercial applications. With lighting contributing up to 40% of energy consumption in a commercial dwelling sensors are a great way to reduce that. MK Sensors are easy to install and have flush and surface mounted variants available, making them ideal for most interiors.
The MK K4015 is a 6A photocell with a PIR sensor. It has a white finish and is suitable for flush mounting in to the ceiling.

Technical Data

MAXIMUM RECOMMENDED MOUNTING HEIGHT: 3.0m

RANGE: Cone-shaped detection pattern, diameter (at floor level) = 2.4 x mounting height

OFF DELAY: 5 minutes – 96 hours – adjustable (35 minutes max via K4050)

PHOTOCELL: Adjustable 50-5000 lux

COLOUR: White

MATERIAL: Flame retardant ABS

WEIGHT: 70g excluding cable

IP RATING: 4X

OPERATING VOLTAGE: 230V 50Hz (UK & Europe)

PRODUCT RATING & RECOMMENDED CIRCUIT PROTECTION: 10 Amps

MAXIMUM RECOMMENDED LOAD: 6 Amps

K4015 – Superior PIR with Photocell – Slim Flush

Fixing

Connection

Only suitably qualified personnel should install this equipment.

off on

Note:

The K4015 is a high performance presence detector with photocell. The photocell can be programmed to hold

lights when areas become occupied (if the daylight contribution is sufficiently high) and to switch lights in

occupied areas as the daylight contribution falls (Active mode). By factory-default the photocell is set to Passive

mode – it will not turn lights OFF when an area is occupied regardless of natural light levels.

The K4015 is suitable for flush mounting in a suspended ceiling tile, maximum 54mm thick and with a minimum

clearance of 125mm between the front surface of the tile and the hard ceiling behind. The K4015 should be

mounted in the centre of the group of luminaires to be controlled. Cut a 50mm diameter (64mm if using an

K4055 flush ring or K4054 plasterboard fixing kit) circular hole in the tile, feed the flying lead and detector through

the hole and secure into position with the locking ring. Twisting the locking ring will release the detector should this

be necessary.

Do not position within 25cm of a luminaire.

The K4015 is supplied with a flying lead which should be taken into the first luminaire on the circuit to be

controlled, from where it will pick up its 230V supply. Control of a group of luminaires is achieved by connecting all

the luminaires in the group (typically 4) in parallel with the switched live output of the K4015.

Commissioning 

The factory default settings will be appropriate for most applications. However, the installer does have the facility

to re-programme a wide range of parameters using the infrared programming tool, K4053. Please read carefully

the operating instructions that accompany the K4053 prior to performing a programming operation.

Below is a table showing the pre-set factory settings and a brief explanation of each parameter. These

parameters may be re-programmed any number of times and all settings will be retained in the event of a power

Quality MK sensor from the superior range which can be programmed using the k4050. Grab a bargain while stocks last.

Additional information

Weight1.0 kg